Tandem crane with two crane bridges, four wire rope hoists and pallet gripper

Single girder overhead travelling crane

Powerhouse with strength in reserve

The single girder overhead travelling crane lifts safe working loads to 16,000 kg. The crane bridge girders are adapted individually to the ceiling construction with different connection variants. This allows optimum utilisation of space. The lifting height can be increased further by using a cantilever crab with extremely low headroom or a chain hoist in extra short headroom trolley design. In their standard version all bridge cranes are equipped with festoon cable power supply line along the crane bridge and with control pendants. Radio control is possible on request.

Competent local partners, many of whom are certified, plan, produce and install single girder overhead travelling cranes with high-quality technology from STAHL CraneSystems. You can find the right contact on our contacts page.

  • Flexible, adaptable through different installation variants
  • Low-maintenance, low-noise direct drive with disc brake and centrifugal mass
  • Smooth starting and braking characteristics: with frequency inverter as an option
  • Explosion-proof versions or off-standard solutions through engineering
  • Worldwide network of certified partners, crane manufacturers and system builders
  • Single girder overhead travelling crane with SH wire rope hoist in a low warehouse in Germany

    Thanks to the design of this single girder overhead travelling crane, which was adapted individually to the hall situation, a low ware­house was converted into a production hall.

  • Single girder overhead travelling crane with two SH wire rope hoists at the sluices of the Camporredondo dam in northern Spain.

    A single girder overhead travelling crane is used to open and close the cofferdam sluices for maintenance work on a sluice.

  • Four single girder overhead travelling cranes with SH wire rope hoists in a production hall of the company Riva in Backnang.

    Single girder overhead travelling cranes with components from STAHL CraneSystems see to a smooth flow of material in a factory.

  • Five single girder overhead travelling cranes with two SH wire rope hoists work in the open.

    This factory site boasts a total of five single girder overhead travelling cranes, each with two SH wire rope hoists working in tandem. They help to load casting moulds on to trucks.

  • Jacked single girder overhead travelling crane with ST20 chain hoist in the measurement laboratory of the German PTB national metrology institute in Braunschweig.

    This double jacked, individually adapted single girder overhead travelling crane makes optimum use of the height of the hall.

Models

The different models and trolley variants allow not only a wide variety of uses, but also very individualised solutions tailored to specific requirements.

  • Diagram of the version ›EL-A‹

    Version ›EL-A‹

  • Diagram of the version ›EL-B‹

    Version ›EL-B‹

  • Diagram of the version ›EL-C‹

    Version ›EL-C‹

More information

LNG slewing jib crane with wire rope hoist

Slewing jib crane

The flexible, economical solution for many fields of work.

 Slewing jib crane

Double girder overhead travelling cranes at a large plant in the Arabian region.

Double girder overhead travelling crane

Move large, bulky loads up to 250,000 kg in weight safely and precisely.

 Double girder overhead travelling crane

Single girder suspension crane with SH wire rope hoist fastened to the ceiling of a hall.

Single girder suspension crane

The optimum solution for small and low factory halls for loads up to 10,000 kg.

 Single girder suspension crane