Single girder suspension crane with SH wire rope hoist fastened to the ceiling of a hall.

Single girder suspension crane

Space-saver in small or low halls

The single girder suspension crane requires very little space and runs on the bottom flange of the crane runway, which is mounted on roof beams or directly on the ceiling. The complete width of the hall is thus available. The distance between the load hook and side walls is extremely small in this case. With this type of crane it is possible to connect various suspension cranes with the help of a crane interlock to enable them to pass hoists with or without loads. In this way it is possible to reach any and every point in a combined system. Passing on a spur runway is also possible.

Competent local partners, many of whom are certified, plan, produce and install single girder suspension cranes with high-quality technology from STAHL CraneSystems. You can find the right contact on our contacts page.

  • Minimal approach dimensions and low headroom for optimal utilisation of small, low halls
  • Crane interlock for transporting material over different aisles
  • Explosion-proof versions or off-standard solutions through engineering
  • Worldwide network of certified partners, crane manufacturers and system builders
  • STAHL CraneSystems: International projects – giant cranes at SR Technics

    Single girder suspension cranes from STAHL CraneSystems with spans between 12 and 51 metres are used in a hangar.

  • Single girder suspension crane with SH wire rope hoist at the German PTB national metrology institute in Braunschweig.

    A single girder suspension crane with four roof beams transports machinery parts and prototypes.

  • Single girder suspension cranes with SHF 30 and SHF 60 wire rope hoists

    All the cranes are equipped with frequency-controlled drives to be able to move the delicate engine parts extremely slowly and as far as possible without swinging.

  • Three suspension cranes with special suspension were installed for an African airline for maintenance work on aircraft.

    Single girder suspension cranes with special suspensions are used in a maintenance hangar in Kenya.

Models

The different models and trolley variants allow not only a wide variety of uses, but also very individualised solutions tailored to specific requirements.

  •  Diagram of the version ›EH-A‹

    Version ›EH-A‹

  • Diagram of the version ›EH-B‹

    Version ›EH-B‹

More information

LNG slewing jib crane with wire rope hoist

Slewing jib crane

The flexible, economical solution for many fields of work.

 Slewing jib crane

Double girder overhead travelling cranes at a large plant in the Arabian region.

Double girder overhead travelling crane

Move large, bulky loads up to 250,000 kg in weight safely and precisely.

 Double girder overhead travelling crane